Cylinder Block, Liners, Pistons and Rods/Measure Cylinder Liner Standout (Height above Block) MEASURE CYLINDER LINER STANDOUT (HEIGHT ABOVE BLOCK) IMPORTANT: Remove all old gasket material, rust, carbon, and other foreign material from top deck of block. Gasket surface must be clean. Use compressed air to remove all loose foreign material from cylinders and top deck. RG5829 -UN-12AUG91 RG5813 -UN-08MAR94 NOTE: Liners having obvious defects must be replaced as a matched piston and liner set. 1. Bolt liners down using cap screws and flat washers. Flat washers should be at least 3.18 mm (1/8 in.) thick. Tighten cap screws to 68 N·m (50 lb-ft). 2.
Use JDG451 Gauge along with D17526CI (English, in.) or D17527CI (Metric, mm) Dial Indicator (B) or KJD10123 Gauge to measure the height (C) of bolted down liners (A) that are not obviously defective before removal from block (D). Cap screws must be tightened to 68 N·m (50 lb-ft) to achieve an accurate reading. 10 12 NOTE: Variations in measurement readings may occur within one cylinder and/or between adjacent cylinders. A—Cylinder Liner B—Dial Indicator 3. Measure each liner in four places, approximately at 1, C—Liner Height 5, 7 and 11 O’clock positions as viewed from the rear of D—Cylinder Block the engine (flywheel end). Record all measurements. 4.
Remove any liner that does not meet standout specification at any location and measure liner flange thickness, as explained later in this group. Use liner shims or replace piston/liner sets as necessary. LINER HEIGHT SPECIFICATIONS New Liner Height Above Block . . . . . . . . . . . . . . 0.051—0.127 mm (0.002—0.005 in.) RG,CTM42,G10,21-19-14FEB95 CTM42 (24MAR95) 10-12 6076 Diesel Engines—S.N. (500000— ) 160101 PN=97