John Deere 400 6076 — John Deere 400 6076 User Manual

Cylinder Block, Liners, Pistons and Rods/Remove Pistons and Connecting Rods NOTE: Connecting rod bearing-to-journal oil clearance should be measured before removing piston/rod assembly. 6. Rod bearing-to-journal oil clearance can be checked with PLASTIGAGE if rod is connected to crankshaft. If rod is out of engine, measure ID of assembled connecting rod bearings and compare with OD of crankshaft journal. RG5807 -UN-12AUG91 RG5806 -UN-12AUG91 NOTE: Use PLASTIGAGE as directed by the manufacturer. Remember, the use of PLASTIGAGE will determine bearing journal clearance, but will not indicate the condition of either surface. IMPORTANT:

DO NOT use pneumatic wrench to tighten connecting rod cap screws. Using pneumatic wrenches may cause thread damage. Keep bearing inserts with their respective rods and caps. Mark rods, pistons, and caps to insure correct assembly in same location. 10 11 7. Remove rod cap screws and rod caps (A) with bearings (B). RG,CTM42,G10,2 -19-14FEB95 8. Gently tap piston (A) through top of cylinder block from the bottom. (Crankshaft shown removed.) NOTE: Once piston rings have cleared cylinder liner, hold on to piston to prevent piston from dropping. RG5808 -UN-12AUG91 IMPORTANT:

If liners are to be reused, be extremely careful not to let connecting rod hit liner bore when removing piston/liner assembly. Pistons and liners are selectively fitted to maintain piston-to-liner clearance. Always keep matched pistons and liners together as a set and each set MUST BE installed in the same cylinder as removed. CTM42 (24MAR95) 10-11 6076 Diesel Engines—S.N. (500000— ) RG,CTM42,G10,3 -19-29OCT92 160101 PN=96