John Deere 400 6076 — John Deere 400 6076 User Manual

Cylinder Block, Liners, Pistons and Rods/Remove Pistons and Connecting Rods 4. Use approximately 51 mm (2.0 in.) long cap screws (A) and 5/8 in. ID x 1-3/4 in. OD x 3.18 mm (1/8 in.) thick washers (B) to bolt down cylinder liners (C) in the seven locations as shown. Tighten cap screws to 68 N·m (50 lb-ft). RG3819 -UN-07DEC88 NOTE: Do not rotate crankshaft with cylinder head removed unless liners are bolted down. Bolt liners down before removing pistons. IMPORTANT: Cap screws and washers must be tightened to the above specification to achieve an accurate reading when checking liner standout (height above block).See MEASURE LINER STANDOUT (HEIGNT ABOVE BLOCK), later in this group.

As the cylinder liner wears, a ridge is formed at the top of piston ring travel zone. If this ridge gets too high, pistons and rings can be damaged when they are removed. Remove any ridge from liner bores with a scraper or ridge reamer before removing pistons. 10 10 5. Before removing pistons, visually inspect condition of cylinder liners with pistons at bottom dead center “BDC”. Liners will require replacement if: —The crosshatch honing pattern is not visible immediately below the top ring turn around area. —Liners are pitted or contain deep vertical scratches that can be detected by the fingernail. No further inspection is required if any one of the above conditions are found.

RG,CTM42,G10,41-19-14FEB95 CTM42 (24MAR95) 10-10 6076 Diesel Engines—S.N. (500000— ) 160101 PN=95