Cylinder Block, Liners, Pistons and Rods/Disassemble and Clean Piston CLEAN CYLINDER LINERS 1. Use a stiff bristle brush to remove all debris, rust, and scale from O.D. of liners, under liner flange, and in O-ring packing areas. Make certain there are no nicks or burrs in areas where packings will seat. IMPORTANT: Do not use gasoline, kerosene, or commercial solvents to clean liners. Solvents will not remove all the abrasives from liner walls. 2. Thoroughly clean liner I.D. with a 50 per cent solution of hot water and liquid detergent. 3. Rinse thoroughly and wipe dry with a clean rag. 4. Swab out liner as many times as necessary with clean SAE 10W oil. 5.
Clean liner until a white rag shows no discoloration. 10 15 RG,CTM61,G10,9 -19-02APR93 DISASSEMBLE PISTON/ROD ASSEMBLY AND CLEAN PISTON 1. Remove piston snap rings. Remove piston pin and connecting rod from piston. RG5228 -UN-13DEC88 NOTE: Discard snap rings, DO NOT reuse. RG,CTM86,G10,11-19-14FEB95 2. Remove piston rings (B) using the JDE93 Piston Ring Expander (A). Discard rings. RG5229 -UN-13DEC88 CTM42 (24MAR95) 10-15 6076 Diesel Engines—S.N. (500000— ) RG,CTM86,G10,12-19-14FEB95 160101 PN=100