John Deere 400 6076 — John Deere 400 6076 User Manual

Cylinder Block, Liners, Pistons and Rods/Measure Piston Skirt OD MEASURE PISTON SKIRT OD 1. Measure piston skirt diameter (B) at right angles to piston pin bore (C) 19.1 mm (0.75 in.) from the bottom of the piston (A). 2. Measure cylinder liner as directed later in this group and compare with piston measurement. PISTON SKIRT DIAMETER SPECIFICATION RG5232 -UN-13DEC88 Piston OD: 19.1 mm (0.75 in.) from Bottom of Skirt . . . . . . . . . . . . . . . . . . 115.771—115.789 mm (4.5579—4.5586 in.) RG,CTM42,G10,35-19-17MAR95 3. Place piston (without rings) in matched liner. 4. Compare liner ID measurement with piston skirt OD measurement to determine piston-to-liner clearance (A).

Piston-to-liner clearance specifications are: 10 21 PISTON-TO-LINER CLEARANCE New Part . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.076—0.124 mm (0.0030—0.0049 in.) Maximum Wear Tolerance . . . . . . . . . . . . . . . . . . . . . 0.152 mm (0.0060 in.) Replace piston and liner as a matched set if clearance exceeds limit. NOTE: Pistons and liners require replacement if liner taper or out-of-roundness (top-to-bottom in ring travel area) is more than 0.051 mm (0.0020 in). See MEASURE CYLINDER LINERS, later in this group. RG5233 -UN-13DEC88 RG,CTM42,G10,36-19-17MAR95 CTM42 (24MAR95) 10-21 6076 Diesel Engines—S.N. (500000— ) 160101 PN=106