Cylinder Block, Liners, Pistons and Rods/Measure Liner Flange Thickness MEASURE CYLINDER LINER ID IMPORTANT: ALWAYS measure liners at room temperature. A—Measure liner bore parallel to piston pin at top end of ring travel. B—Measure bore in same position at bottom end of ring travel. C—Measure bore at right angle to piston pin at top end of ring travel. R25922 -UN-13DEC88 D—Measure bore in same position at bottom end of ring travel. Compare measurements A, B, C, and D to determine if liner is tapered or out-of-round. Compare liner ID with piston OD. CYLINDER LINER SPECIFICATIONS 10 22 Maximum Wear or Taper in Ring Travel Area . . . . . . . . . . . . . . . . . . . . . . . . . . . .
0.051 mm (0.002 in) Maximum Liner Out-of-Round . . . . . . . . . . . . . . . . . . . . . 0.051 mm (0.002 in.) Maximum Piston-to-Liner Clearance . . . . . . . . . . . . . . . . . . 0.15 mm (0.006 in.) NOTE: Replace piston and liner (as a set) if they exceed wear specifications given. S11,2010,JQ -19-14FEB95 MEASURE CYLINDER LINER FLANGE THICKNESS Measure cylinder liner flange thickness at several locations. If liner flange is not within specifications, replace piston and liner set. RG4727 -UN-13DEC88 LINER FLANGE SPECIFICATIONS Flange Thickness . . . . . . . . . . . 8.175—8.225 mm (0.322—0.324 in.) CTM42 (24MAR95) 10-22 6076 Diesel Engines—S.N. (500000— ) S11,2510,AV -19-16AUG94 160101 PN=107