Cylinder Block, Liners, Pistons and Rods/Inspect and Measure Connecting Rod Bearings INSPECT AND MEASURE CONNECTING ROD BEARINGS IMPORTANT: Never use new connecting rod cap screws when checking rod bearing ID. Use new cap screws only for final assembly of connecting rods. Rod bearing-to-journal oil clearance can be checked with PLASTIGAGE, if rod is connected to crankshaft. If rod is out of engine, measure ID of connecting rod bearings and compare with OD of crankshaft journal. 1. With crankshaft removed, measure connecting rod journal OD at several points. RG5705 -UN-01APR91 2. Install connecting rod cap (A) on rod (B) with bearings (C) in correct position. 3.
Tighten rod cap-to-rod using TORQUE-TURN method. (See USE TORQUE-TURN METHOD FOR PROPER TORQUE, described later in this group.) 10 23 RG,CTM42,G10,40-19-29OCT92 4. Using an inside micrometer (A) measure ID of bearing. 5. Subtract OD of crankshaft journals from ID of rod bearings to obtain oil clearance. RG3824 -UN-13DEC88 6. Compare measurements with the following specifications. CONNECTING ROD BEARING AND JOURNAL SPECIFICATIONS Crankshaft Journal OD . . . . . . . . . . . . . . . . . . . 76.150—76.180 mm (2.9980—2.9992 in.) Assembled Rod Bearing ID . . . . . . . . . . . . . . . . 76.210—76.260 mm (3.0005—3.0025 in.) Oil Clearance (new parts) . . . . . . . . . . . . . . . . . .
0.030—0.110 mm (0.0012—0.0044 in.) Wear Limit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.152 mm (0.0060 in.) 7. Inspect connecting rod bearings for wear or damage. If bearings are worn or not within specification, replace both connecting rod bearing and rod pin bearing. CTM42 (24MAR95) 10-23 6076 Diesel Engines—S.N. (500000— ) S11,2010,JR -19-14FEB95 160101 PN=108