Cylinder Block, Liners, Pistons and Rods/Inspect Rod and Cap INSPECT CONNECTING ROD AND CAP 1. Inspect rod and cap for wear or damage, such as chips or cracks in the area of the tongue-and-groove joints (A). RG3749 -UN-13DEC88 2. Inspect in and around cap screw holes (B) in cap. If any defects are found, replace rod and cap. S11,0402,AE -19-08MAR94 3. Carefully clamp rod in a soft-jawed vise (cap end upward). 4. Install cap WITHOUT bearing inserts. IMPORTANT: Never use new connecting rod cap screws when checking rod bore ID. Use new cap screws only for final assembly of connecting rods. RG4982 -UN-13DEC88 10 24 5.
Initially tighten blind hole cap screw to 27 N·m (20 lb-ft), then tighten open hole cap screw to same torque. 6. Tighten cap screws to 75 N·m (55 lb-ft), then tighten each cap screw an additional 90˚—100˚. (See TORQUE-TURN CONNECTING ROD CAP SCREWS, later in this group.) S11,2010,JS -19-14FEB95 CTM42 (24MAR95) 10-24 6076 Diesel Engines—S.N. (500000— ) 160101 PN=109