Cylinder Block, Liners, Pistons and Rods/Inspect Rod and Cap 6. Using an inside micrometer, measure rod bore at center of bore and record measurements as follows: A. At right angle to rod/cap joint. B. At 45˚ left of measurement “A”. C. At 45˚ right of measurement “A”. ROD BORE SPECIFICATIONS Rod Bore ID . . . . . . . . . . . . . . . . . . . . . . . . . . 81.051—81.077 mm (3.191—3.192 in.) RG6661 -UN-11MAR93 7. Compare the measurements. If difference between the greatest and least measurement is more than 0.04 mm (0.0016 in.), the rod and cap are out-of-round. Replace both connecting rod and cap. 8. Remove cap screw (D). Using a feeler gauge, measure gap at rod/cap joint (E).
If gap is excessive, mating surfaces of rod and cap are worn and must be replaced. ROD CAP SPECIFICATION Maximum End Gap . . . . . . . . . . . . . . . . . . . . . 0.25 mm (0.010 in.) 10 25 S11,2010,JU -19-12APR93 9. Measure connecting rod pin bore-to-crankshaft bore center-to-center dimension (A) and compare with specification given. If measurement is not within specification, replace rod. CENTERLINE OF PISTON BORE-TO-CRANKSHAFT BORE New part . . . . . . . . . . . . . . 222.20—222.30 mm (8.748—8.752 in.) RG6455 -UN-22OCT92 RG,CTM42,G10,37-19-16AUG94 CTM42 (24MAR95) 10-25 6076 Diesel Engines—S.N. (500000— ) 160101 PN=110