Cylinder Block, Liners, Pistons and Rods/Inspect Piston Pins and Bushings INSPECT PISTON PINS AND BUSHINGS 1. Insert piston pin (A) through piston pin bushing and carefully clamp in a soft-jawed vise. 2. Rotate connecting rod (B) back and forth several times to make sure connecting rod moves freely on piston pin. RG3172 -UN-13DEC88 3. Remove piston pin from vise and connecting rod. S11,2010,DM -19-08MAR94 4. Insert pin from either side of rod bushing. If pin is free on one end, but tight on the other, the bore could be tapered (A). If pin enters freely from both sides, but is tight in the center, bore is bellmouthed (B). 5. Measure ID of rod pin bushing and OD of piston pin.
Compare measurements with specifications given below: RG4983 -UN-13DEC88 PISTON PIN BORE SPECIFICATIONS 10 26 OD of Piston Pin . . . . . . . . . . . . . . . . . . . . . . . 47.597—47.613 mm (1.8739—1.8745 in.) ID of Pin Bore in Piston . . . . . . . . . . . . . . . . . . 47.620—47.630 mm (1.8748—1.8752 in.) ID of Installed Rod Pin Bushing (After Boring) . . . . . . . . . . . . . . . . . . . . . . . . . 47.655—47.681 mm (1.8762—1.8772 in.) Rod Pin-to-Bushing Oil Clearance . . . . . . . . . . . . 0.042—0.084 mm (0.0017—0.0033 in.) Maximum Serviceable . . . . . . . . . . . . . . . . . . . . . . . . . 0.102 mm (0.0040 in.) 6. If necessary, remove and replace piston pin bushing.
See REMOVE PISTON PIN BUSHING, CLEAN AND INSPECT PIN BORE, later in this group. S11,2010,JG -19-14SEP94 CTM42 (24MAR95) 10-26 6076 Diesel Engines—S.N. (500000— ) 160101 PN=111