John Deere 400 6076 — John Deere 400 6076 User Manual

Cylinder Block, Liners, Pistons and Rods/Clean and Inspect Piston Pin Bushing Bore in Rod REMOVE PISTON PIN BUSHING IMPORTANT: Do not use any power tool to remove or install piston pin bushing. 1. If necessary, remove pin bushing with the JDG337 Connecting Rod Bushing Service Set. Use the following tools from the service set: A—JDG339 Cup B—JDG338 Adapter C—JDE98-4 Driver D—STD36104 Forcing Screw with Washer IMPORTANT: Use care to properly align the JDE98-4 Driver with bushing so that the connecting rod bushing bore is not damaged. RG4985 -UN-13DEC88 10 27 S11,2010,J1 -19-12APR93 CLEAN AND INSPECT CONNECTING ROD PIN BORE 1.

Clean rod bushing bore using a medium grit emery cloth, as burrs will distort bushing. Install bushing on opposite side of rod burr. RG5227 -UN-13DEC88 2. If necessary, file a slight chamfer (A) around bore to remove any sharp edges. Chamfer will also aid in bushing installation. 3. Measure rod pin bore in three places approximately 45˚ apart. Compare the measurements with the specifications given below: CONNECTING ROD PIN BORE SPECIFICATIONS (Bushing Removed) ID of Rod Pin Bore . . . . . . . . . . . . . . . . . . . . . 52.354—52.380 mm (2.0612—2.0622 in.) IMPORTANT:

If connecting rod pin bore diameter is not within specification or bushing has spun in rod, discard rod and replace with a new one. CTM42 (24MAR95) 10-27 6076 Diesel Engines—S.N. (500000— ) S11,2010,JJ -19-12APR93 160101 PN=112