Cylinder Block, Liners, Pistons and Rods/Inspect and Clean Cylinder Block 2. Be sure liner support flange (A) is free of any burrs. If burrs are present, use a small half-moon file and LIGHTLY file (in a circular motion) burr off at approximately a 60˚ angle. DO NOT let file hit top of cylinder block while filing. NOTE: DO NOT file liner support flange excessively. Excess filing can damage liner support flange and allow an improper liner fitting. Thoroughly clean all filings from cylinder block (B). 3. Carefully inspect block for cracks or damage. If a cracked block is suspected, pressure-test the block.
A procedure for pressure testing is outlined in FOS (Fundamentals of Service) Manual-ENGINES. Replace cracked or damaged block. RG3329 -UN-13DEC88 RG5796 -UN-12AUG91 COUNTERBORE DEPTH AND LINER FLANGE SPECIFICATIONS Cylinder Liner Counterbore Depth . . . . . . . . . . . . 8.105—8.155 mm (0.319—0.321 in.) Liner Flange Thickness . . . . . . . . . . . . . . . . . . . 8.175—8.225 mm (0.322—0.324 in.) 4. When determined that the cylinder block is serviceable, remove cylinder head locating dowels. Clean out all threaded holes for cylinder head cap screws in top deck of cylinder block. Use JDG681A Tap or an equivalent 9/16-12 UNC-2A tap approximately 114.3 mm (4.5 in.) long.
Use compressed air to remove any debris or fluid which may be present in the cap screw hole. 10 31 5. Install new locating dowel pins in cylinder block. RG,CTM42,G10,8 -19-17MAR95 CTM42 (24MAR95) 10-31 6076 Diesel Engines—S.N. (500000— ) 160101 PN=116