Cylinder Block, Liners, Pistons and Rods/Measure Cylinder Block CLEAN CYLINDER LINER O-RING BORE 1. Use D17015BR O-Ring Bore Cleaning Brush to thoroughly clean all debris from O-ring bore. NOTE: Use brush exactly as directed by the manufacturer. RG5812 -UN-12AUG91 10 32 RG,CTM42,G10,9 -19-12APR93 MEASURE CYLINDER BLOCK 1. Assemble and measure main and thrust bearing bores. Compare measurements with specifications given below: MAIN AND THRUST BEARING SPECIFICATIONS Main and Thrust Bearing Bore ID Without Bearing . . . . . . . . . . . . . . . . . . . . . . . 92.125—92.151 mm (3.627—3.628 in.) Main Bearing Surface Width . . . . . . . . . . . . . . . .
36.28—36.78 mm (1.428—1.448 in.) Thrust Bearing (No. 5 Main) Surface Width . . . . . . . . . . . . . . . . . . . . . . . . . 37.44—37.54 mm (1.474—1.478 in.) Overall Thrust Bearing Cap Width . . . . . . . . . . . . 39.16—39.66 mm (1.542—1.561 in.) If any main or thrust bearing cap assembled ID is not within specification, blank (generic) bearing caps are available and must be lined bored to specification. (See Group 15-Crankshaft, Main Bearings, and Flywheel.) CTM42 (24MAR95) 10-32 6076 Diesel Engines—S.N. (500000— ) S11,2010,JH -19-29OCT92 160101 PN=117