Crankshaft, Main Bearings and Flywheel/Remove Flywheel CHECK PILOT BEARING BORE CONCENTRICITY 1. Mount dial indicator on flywheel housing face and position pointer to contact ID of pilot bearing bore in flywheel. R22214 -UN-14DEC88 2. Rotate flywheel by turning crankshaft. Read total dial indicator movement. BEARING BORE CONCENTRICITY SPECIFICATION Maximum Variation . . . . . . . . . . . . . . . . . . . . 0.127 mm (0.005 in.) S55,2015,M -19-08MAR94 REMOVE FLYWHEEL NOTE: SAE 1 and SAE 2 flywheel housings MUST BE removed before flywheel can be removed from engine. See REMOVE SAE 1 AND SAE 2 FLYWHEEL HOUSING, later in this group. N CAUTION: Flywheel is heavy.
Plan a proper lifting procedure to avoid personal injury. RG3836 -UN-14DEC88 15 22 1. Remove two flywheel attaching cap screws (A), and install two pilot studs in their place. 2. Remove remaining cap screws, remove drive hub (if equipped), and carefully pull flywheel from crankshaft. 4. Check condition of dowel pin in crankshaft rear flange. Dowel pin must not be cracked or chipped. Measure protrusion of dowel pin from face of flange. If dowel pin is damaged, or protrusion is not within specifications, replace dowel pin. NOTE: When replacing dowel pin, crankshaft must be removed to prevent damage to crankshaft thrust bearings.
CRANKSHAFT DOWEL PIN SPECIFICATIONS Protrusion From Crankshaft Rear Flange . . . . . . . . . . . . . . . . 13.5—14.5 mm (0.53—0.57 in) CTM42 (24MAR95) 15-22 6076 Diesel Engines—S.N. (500000— ) RG,CTM42,G15,52-19-16AUG94 160101 PN=151