John Deere 400 6076 — John Deere 400 6076 User Manual

Crankshaft, Main Bearings and Flywheel/Check Flywheel Face Flatness CHECK FLYWHEEL HOUSING FACE RUNOUT 1. Mount dial indicator on flywheel. Set pointer to contact PTO mounting surface on flywheel housing at right angles. Pointer should not contact holes in flywheel housing. R22212 -UN-14DEC88 IMPORTANT: Maintain constant end pressure on crankshaft to hold shaft against thrust bearing when measuring flywheel housing face runout. 2. Rotate flywheel by turning crankshaft. Read total dial indicator movement. FLYWHEEL HOUSING FACE RUNOUT SPECIFICATION Maximum Variation . . . . . . . . . . . . . . . . . . . . . 0.20 mm (0.008 in.) S55,2015,L -19-29OCT92 15 21 CHECK FLYWHEEL FACE FLATNESS 1.

Mount dial indicator base on flywheel housing. Position pointer to contact driving ring mounting surface. Do not allow pointer to contact driving ring mounting holes. R22213 -UN-14DEC88 IMPORTANT: Maintain constant end pressure on crankshaft to hold shaft against thrust bearing when measuring flywheel face runout. 2. Rotate flywheel by turning crankshaft. Read total dial indicator movement. Resurface flywheel face or replace as required. FLYWHEEL FACE FLATNESS SPECIFICATION Maximum Variation . . . . . . . . . . . . . . . . . . . . . 0.23 mm (0.009 in.) Maximum Variation per 25 mm (1.0 in.) of Travel . . . . . . . . . . . . . . . . . . . .

0.013 mm (0.0005 in.) CTM42 (24MAR95) 15-21 6076 Diesel Engines—S.N. (500000— ) S11,5005,AM -19-02FEB94 160101 PN=150