Crankshaft, Main Bearings and Flywheel/Inspect, Measure and Repair Flywheel REMOVE TIMING GEAR COVER 1. Remove magnetic pick-up (A, if equipped) and injection pump drive gear cover (B). Discard gasket. 2. Remove timing gear cover (C). Discard gasket. RG5828 -UN-12AUG91 3. Remove oil seal from cover and discard. RG,CTM42,G15,44-19-29OCT92 INSPECT AND MEASURE FLYWHEEL 1. Inspect the clutch contact face for scoring, overheating, or cracks. Replace flywheel if defective. 2. Examine flywheel ring gear for worn or broken teeth. Replace ring gear if defective, as described later in this group. IMPORTANT:
Maintain constant end pressure on crankshaft to hold shaft against thrust bearing when measuring flywheel or housing face. 15 20 3. Measure flywheel housing face run-out, flywheel face flatness, and pilot bearing bore concentricity, as outlined later in this group. Resurface flywheel face or replace as required. S55,2015,N -19-08MAR94 CTM42 (24MAR95) 15-20 6076 Diesel Engines—S.N. (500000— ) 160101 PN=149