Crankshaft, Main Bearings and Flywheel/Replace Timing Gear Cover (6076HRW33, 34, and 35 Engines) REPLACE TIMING GEAR COVER (6076HRW33, 34, AND 35 ENGINES) —ENGINE INSTALLED IN VEHICLE 6076HRW33, 34, and 35 Engines used in 8100, 8200, and 8300 Tractors are equipped with front frame/oil sump, refer to TM1575 (8100, 8200, 8300, and 8400 Tractors—Repair) for access to front frame/oil sump-to-engine block cap screws. 9. Remove front oil seal from timing gear cover and discard seal. 10. Remove front wear sleeve from crankshaft flange and discard sleeve. To Remove Timing Gear Cover: To Install Timing Gear Cover: 1. Remove viscous fan drive, drive housing, and coupler. (Refer to TM1575.) 1.
Thoroughly clean all timing gear cover gasket surfaces and front oil seal bore. 2. Remove crankshaft vibration damper as detailed earlier in this group. NOTE: Front wear sleeve can be installed with timing gear cover removed or installed. 3. Disconnect water piping and remove water pump cover with water bypass tube. Remove and discard gaskets. 2. Install a new front wear sleeve on crankshaft flange (See INSTALL FRONT WEAR SLEEVE, later in this group). 4. Back out all front frame/oil sump-to-engine block cap screws 9.5 mm (0.38 in.) 3. Install timing gear cover (See INSTALL TIMING GEAR COVER, later in this group). 5. Disconnect engine speed sensor connector from sensor. 4.
Install Front oil seal (See INSTALL CRANKSHAFT FRONT OIL SEAL WITH TIMING GEAR COVER INSTALLED ON ENGINE, later in this group). 6. Remove injection pump drive gear cover. 5. Install vibration damper (See INSTALL VIBRATION DAMPER, later in this group). 15 19 7. Slowly lift engine block assembly approximately 6.4 mm (0.25 in.) using safety approved lifting equipment. 6. Tighten front frame/oil sump cap screws as detailed in Group 20, Lubrication System of this manual (See TIGHTEN CAP SCREWS ON FRONT FRAME/OIL SUMP) or TM1575. IMPORTANT: The timing gear cover must not be “dragged” horizontally while in contact with front frame/oil sump gasket. Doing so may damage gasket sealing bead. 7.
Complete final assembly as outlined in TM1575. 8. Remove remaining cap screws and carefully remove timing gear cover. Remove and discard timing gear cover gasket. RG,CTM42,G15,49-19-21MAR95 CTM42 (24MAR95) 15-19 6076 Diesel Engines—S.N. (500000— ) 160101 PN=148