John Deere 400 6076 — John Deere 400 6076 User Manual

Crankshaft, Main Bearings and Flywheel/Install Front Oil Seal INSTALL CRANKSHAFT FRONT OIL SEAL (WITH TIMING GEAR COVER INSTALLED ON ENGINE) IMPORTANT: Whenever front oil seal is replaced, the wear sleeve MUST be replaced also. RG6479 -UN-26OCT92 RG6480 -UN-26OCT92 1. Place JDG720-2 Seal Protector (A) on nose of crankshaft. Lubricate ID of front oil seal lips with clean engine oil. Slide seal with spring side of seal facing engine onto seal protector. Be careful not to roll oil seal lips. 2. Place JDG720-3 Seal Installer onto seal protector against seal. Do not use spacer ring provided with tool set. 3.

With nut and washer installed onto JDG720-1 Forcing Screw, thread forcing screw into nose of crankshaft until it bottoms. 4. Tighten nut against crossplate of installer until installer bottoms onto front face of timing gear cover. 5. Remove installation tools. Verify seal is installed square in bore and that seal lips are not rolled on wear sleeve. 15 18 Oil seal should be 8.4 mm (0.33 in.) below front lip of seal bore. RG,CTM42,G15,43-19-03MAY93 CTM42 (24MAR95) 15-18 6076 Diesel Engines—S.N. (500000— ) 160101 PN=147