John Deere 400 6076 — John Deere 400 6076 User Manual

Crankshaft, Main Bearings and Flywheel/Install Front Wear Sleeve REMOVE CRANKSHAFT FRONT WEAR SLEEVE (WITH TIMING GEAR COVER INSTALLED OR REMOVED) 1. Position JDG786 Front Wear Sleeve Puller on crankshaft nose. RG6474 -UN-26OCT92 RG6475 -UN-26OCT92 2. Center puller on wear sleeve and thread onto sleeve approximately two full turns. 3. Tighten forcing screw until wear sleeve is removed from crankshaft flange. NOTE: To remove wear sleeve from tool, place tool in vise and cut two slots adjacent from each other in wear sleeve using hack saw or parting wheel. Put file or similar flat object in slots and turn wear sleeve out of tool. 4.

Clean crankshaft flange using Brake Kleen or Ignition Cleaner and Drier. RG,CTM42,G15,41-19-03MAY93 15 17 INSTALL CRANKSHAFT FRONT WEAR SLEEVE NOTE: Wear sleeve can also be installed with timing gear cover removed, but seal must be installed with timing gear cover installed. RG6476 -UN-26OCT92 RG6477 -UN-26OCT92 1. Coat ID of new wear sleeve with LOCTITE 609 Retaining Compound. 2. Using JDG467 Driver from JDE3 Installer along with washer and 5/8-11 UNC x 3 in. cap screw that secures damper pulley assembly to crankshaft. Tighten cap screw until driver bottoms. 3. Remove installation tools and clean any sealant from OD of wear sleeve or ID of seal bore.

CTM42 (24MAR95) 15-17 6076 Diesel Engines—S.N. (500000— ) RG,CTM42,G15,42-19-11JUN93 160101 PN=146