Crankshaft, Main Bearings and Flywheel/Replace Flywheel Ring Gear REPLACE FLYWHEEL RING GEAR N CAUTION: Oil fumes or oil can ignite above 193˚C (380˚F). Use a thermometer and do not exceed 182˚C (360˚F). Do not allow a flame or heating element to be in direct contact with the oil. Heat the oil in a well ventilated area. Plan a safe handling procedure to avoid burns. T90596 -UN-14OCT88 RG3838 -UN-14OCT88 1. If ring gear is damaged, place the flywheel on a solid flat surface. 2. Remove ring gear with a brass drift and hammer. IMPORTANT: If flame heat is used, be sure gear is heated uniformly around circumference. DO NOT OVERHEAT. Overheating may destroy original heat treatment of gear.
SEE CAUTION. 3. Heat new ring gear to 148˚C (300˚F) using either heated oil, oven heat, or flame heat. 4. Install ring gear against shoulder of flywheel so chamfered side (A) is on engine side of flywheel. 15 24 S11,2015,FX -19-16SEP92 CTM42 (24MAR95) 15-24 6076 Diesel Engines—S.N. (500000— ) 160101 PN=153