Crankshaft, Main Bearings and Flywheel/Replace Rear Oil Seal Housing (6076HRW33, 34, and 35 Engines) REPLACE REAR OIL SEAL HOUSING (6076HRW33, 34, AND 35 ENGINES)—ENGINE INSTALLED IN VEHICLE 6076HRW33, 34, and 35 Engines used in 8100, 8200, and 8300 tractors are equipped with front frame/oil sump, refer to TM1575 (8100, 8200, 8300, and 8400 Tractors—Repair) for access to front frame/oil sump-to-engine block cap screws. 7. Remove rear oil seal housing (A). 8. Remove rear wear sleeve from crankshaft flange with JDG790 Wear Sleeve Puller Kit as detailed earlier in this group. Clean flange with emery cloth. IMPORTANT:
Remove rear oil seal housing (A) for replacement purposes only, it is not necessary to remove seal housing for rear seal and wear sleeve replacement. To Install Rear Oil Seal Housing: 1. Install rear oil seal housing and check runout. (See INSTALL CRANKSHAFT REAR OIL SEAL HOUSING and CHECK OIL SEAL HOUSING RUNOUT, later in this group.) To Remove Rear Oil Seal Housing: 2. Carefully lower engine onto locating dowels of front frame/oil sump. NOTE: Refer to TM1575 for access to rear crankshaft seal housing area. 1. Remove flywheel cover. 3.
Tighten front frame/oil sump cap screws as detailed in Group 20, Lubrication System of this manual (See TIGHTEN CAP SCREWS ON FRONT FRAME/OIL SUMP) or TM1575. 2. Remove transmission input shaft coupler bolts and pry coupler rearward. NOTE: Use a set screw to separate damper from flywheel, if necesssary. 4. Install a new rear oil seal and wear sleeve assembly. (See INSTALL CRANKSHAFT REAR OIL SEAL AND WEAR SLEEVE, WITHOUT ENGINE DISASSEMBLY, earlier in this group.) 3. Remove torsional damper from flywheel. 15 25 4. Remove flywheel from right side of tractor. 5. Install flywheel. (See INSTALL FLYWHEEL, later in this group.) 5.
Back out all front frame/oil sump-to-engine block cap screws 9.5 mm (0.38 in.) 6. Install torsional damper onto flywheel. (See TM1575.) 6. Slowly lift engine block assembly approximately 6.4 mm (0.25 in.) using safety approved lifting equipment. 7. Pull transmission input shaft coupler forward, install cap screws and tighten to specified torque. (See TM1575.) IMPORTANT: The rear oil seal housing must not be “dragged” horizontally while in contact with front frame/oil sump gasket. Doing so may damage gasket sealing bead. 8. Install flywheel cover. (See TM1575.) 9. Start engine and chack for leaks. CTM42 (24MAR95) 15-25 6076 Diesel Engines—S.N.
(500000— ) RG,CTM42,G15,48-19-21MAR95 160101 PN=154