John Deere 400 6076 — John Deere 400 6076 User Manual

Crankshaft, Main Bearings and Flywheel/Main Bearing Cap Line Bore Specifications MAIN BEARING CAP LINE BORE SPECIFICATION 1. With crankshaft removed from cylinder block, install main bearing caps without bearing inserts. MAIN BEARING CAP BORE SPECIFICATIONS 2. Tighten main bearing cap screws to 203 N·m (150 lb-ft). ID Without Bearings (Standard) . . . . . . . . . . 92.125—92.151 mm (3.627—3.628 in.) Maximum Bore Diameter Variation . . . . . . . . . . . . . . . 0.013 mm (0.0005 in.) 3. Measure ID of all bearing caps, at several locations, with an inside micrometer. Maximum Bore Diameter Taper . . . . . . . . . . . . . . . . .

0.013 mm (0.0005 in.) If any main bearing cap assembled ID is not within specification, blank (generic) bearing caps are available and must be line bored to specification. Replace individual bearing caps as needed. Maximum Straightness Variation (Any Bore-to-Adjacent Bore) . . . . . . . . . . . . . . . . . . . 0.038 mm (0.0015 in.) IMPORTANT: Main bearing cap line boring should be done ONLY by experienced personnel on equipment capable of maintaining bore specifications. Maximum Straightness Variation (5 Center Bores-to-End Bores) . . . . . . . . . . . . . . . . . . 0.08 mm (0.003 in.) Centerline of Bore-to-Top Deck . . . . . . . . . .

352.35—352.50 mm (13.872—13.878 in.) S11,2515,BY -19-21MAR95 15 33 CTM42 (24MAR95) 15-33 6076 Diesel Engines—S.N. (500000— ) 160101 PN=162