John Deere 400 6076 — John Deere 400 6076 User Manual

Crankshaft, Main Bearings and Flywheel/Crankshaft Grinding Guidelines CRANKSHAFT GRINDING GUIDELINES IMPORTANT: Crankshaft grinding should be done ONLY by experienced personnel on equipment capable of maintaining crankshaft size and finish specifications. If the crankshaft is to be reground, use the following recommended procedure: 1. Compare the crankshaft journal measurements taken during inspection and determine the size which the journals are to be reground. In addition to the standard size main and connecting rod bearings, 0.05, 0.25, 0.51 and 0.76 mm (0.002, 0.010, 0.020 and 0.030 in.) undersize bearings are available.

If journals are tapered, out-of-round, scored or damaged, grind the crankshaft and install the proper undersize bearings. 2. If one or more main or connecting rod journals require grinding, then grind all of the main journals or all of the connecting rod journals to the same required size. NOTE: The 0.05 mm (0.002 in.) undersize bearings are used normally to compensate for slight un-even wear on crankshafts. Regrinding is usually unnecessary when this size bearing is used. 3. All journal fillets radii must be free of any sharp grind marks or scratches. The fillet must blend smoothly into the journal and crank cheek. Check the radius with a fillet gage. IMPORTANT:

Care must be taken to avoid localized heating which often produces grinding cracks. IMPORTANT: If undersize bearings are used, check bearing clearance after bearing caps have been tightened to specified torque. If undersize bearings are too tight and clearance is not within specifications, the journal and bearing will be wiped clean of all oil. This would result in premature wear of parts. 15 34 S11,2015,DM -19-16AUG94 CTM42 (24MAR95) 15-34 6076 Diesel Engines—S.N. (500000— ) 160101 PN=163