John Deere 400 6076 — John Deere 400 6076 User Manual

Crankshaft, Main Bearings and Flywheel/Crankshaft Grinding Guidelines CRANKSHAFT GRINDING GUIDELINES—CONTINUED 4. Cool the crankshaft while grinding by using coolant generously. DO NOT crowd the grinding wheel into the work. NOTE: When thrust surfaces are reground and an oversize washer is used, crankshaft end play specification must be maintained to within 0.038—0.380 mm (0.0015—0.0150 in.) (See CHECK CRANKSHAFT END PLAY, earlier in this group.) IMPORTANT: Grind crankshaft with journals turning counterclockwise, as viewed from the front end of crankshaft. Lap or polish journals in opposite direction of grinding. 7.

Stone the edge of all oil holes in the journal surfaces smooth to provide a radius of approximately 1.50 mm (0.060 in.). 5. Polish or lap the ground surfaces to the specified finish to prevent excessive wear of the journals. (See CRANKSHAFT GRINDING SPECIFICATIONS, later in this group.) 8. When finished grinding, inspect the crankshaft for cracks with the Florescent Magnetic Particle method, or similar method. NOTE: Production crankshafts are induction hardened and shotpeened at the factory. Field shotpeening is not recommended due to the equipment required and part geometry. 9. De-magnetize the crankshaft. 10. Thoroughly clean the crankshaft and oil passages with solvent.

Dry with compressed air. 6. If the thrust surfaces of the crankshaft are worn or grooved excessively, regrind and polish. Maintain the specified radius between each thrust surface and the bearing journal. An oversize thrust washer set containing one standard washer and two 0.18 mm (0.007 in.) oversize washers is available. (See THRUST BEARING NEW PART SPECIFICATIONS, later in this group.) 15 35 S11,2015,HD -19-08MAR94 CTM42 (24MAR95) 15-35 6076 Diesel Engines—S.N. (500000— ) 160101 PN=164