Crankshaft, Main Bearings and Flywheel/Replace Crankshaft Oil Pump Drive Gear REPLACE (CRANKSHAFT) OIL PUMP DRIVE GEAR IMPORTANT: Protect all machined surfaces of crankshaft from grinding debris and weld spatter when removing old gear and installing new gear. DO NOT use a cutting torch to remove failed gear. 1. Using a rotary grinding wheel or parting disc, grind weld beads (A) until flush with crankshaft flange. 2. Remove gear (B) by alternately striking gear at each weld location using a brass drift and soft lead mallet. 3. After removal of gear, clean up OD of crankshaft flange and remove any burrs or remaining weld bead to eliminate interference when installing new gear. N CAUTION:
Oil fumes or oil can ignite above 193˚C (380˚F). Use a thermometer and do not exceed 182˚C (360˚F). Do not allow a flame or heating element to be in direct contact with the oil. Heat the oil in a well-ventilated area. Plan a safe handling procedure to avoid burns. RG5018 -UN-14DEC88 4. Heat new gear to 148˚C (300˚F) using either heated oil or oven heat. 15 38 IMPORTANT: DO NOT OVERHEAT GEAR. SEE CAUTION. Overheating may also destroy original heat treatment of gear. 5. Drive gear onto crankshaft flange until flush against shoulder. NOTE: When driving oil pump drive gear onto crankshaft flange. The beveled edge of gear teeth should face the flywheel end of crankshaft. 6.
Weld two 25.4 mm (1 in.) beads according to illustration using 1/8 in. diameter 7018 welding rod. Grind away excess weld to eliminate the possibility of interference with cylinder block. CTM42 (24MAR95) 15-38 6076 Diesel Engines—S.N. (500000— ) S11,2515,BG -19-08AUG94 160101 PN=167