John Deere 400 6076 — John Deere 400 6076 User Manual

Crankshaft, Main Bearings and Flywheel/Replace Crankshaft Gear REPLACE CRANKSHAFT GEAR NOTE: Remove crankshaft gear for replacement only; it is not necessary to remove gear for crankshaft removal. 7. Heat crankshaft gear (if removed) to 148˚C (300˚F), using either heated oil or oven heat. IMPORTANT: If flame heat is used, be sure gear is heated uniformly around circumference. DO NOT OVERHEAT. SEE CAUTION. Overheating may also destroy original heat treatment of gear. 1. Install JDG787 Thread Protector in nose of crankshaft. 2. Protect crankshaft wear sleeve surface with masking tape. 3. Remove crankshaft gear using D01251AA* Puller or an equivalent puller. 8.

Install Woodruff key in crankshaft. 4. Discard gear after removal. 9. Place gear on crankshaft flange. Be sure key on crankshaft is properly aligned with keyway in gear. 5. Remove Woodruff key from crankshaft keyway. IMPORTANT: When installing gear, do not gouge or nick crankshaft flange. 6. Remove masking tape. 10. Use JDH7 Driver to firmly seat gear against crankshaft flange. IMPORTANT: Crankshaft gear must be installed on crankshaft before crankshaft is installed in engine, otherwise damage to thrust bearings could occur. N CAUTION: Oil fumes or oil can ignite above 193˚C (380˚F). Use a thermometer and do not exceed 182˚C (360˚F).

Do not allow a heating element to be in direct contact with the oil. Heat the oil in a well-ventilated area. Plan a safe handling procedure to avoid burns. 11. Once gear cools, reseat gear using JDH7 Driver. 15 39 *Part of D01047AA 17-1/2 and 30-Ton Puller Set. RG,CTM61,G15,27-19-30APR93 CTM42 (24MAR95) 15-39 6076 Diesel Engines—S.N. (500000— ) 160101 PN=168