John Deere 400 6076 — John Deere 400 6076 User Manual

Crankshaft, Main Bearings and Flywheel/Install Main Bearings and Crankshaft INSTALL CRANKSHAFT RG5834 -UN-12AUG91 RG3741 -UN-14DEC88 N CAUTION: Crankshaft is heavy. Plan a proper lifting procedure to avoid injuries. 5. Tighten No.’s 1, 2, 3, 4, 6 and 7 main bearing cap screws to 68 N·m (50 lb-ft). Hand-tighten No. 5 main thrust bearing cap screws. 1. Carefully position crankshaft onto main bearing inserts using a hoist and lift sling. 6. Gently pry crankshaft rearward and then forward to align thrust washers on No. 5 main thrust bearing. 2. Dip entire main bearing cap screws in clean engine oil and position them in the main bearing caps.

Apply a liberal amount of oil to bearing inserts in caps. NOTE: DO NOT PRY crankshaft on No. 5 main thrust bearing. 7. Tighten No. 5 main thrust bearing cap screws to 68 N·m (50 lb-ft). 15 42 3. Install each bearing cap (B), bearings (C), and cap screws with washer (A) with the recesses and tabs aligned in matching order. Make sure bearing tabs also match up before tightening cap screws. 8. Tighten all main bearing cap screws (including No. 5) to 203 N·m (150 lb-ft). NOTE: Make sure main bearing caps are installed on the bearing bosses from which they were removed. The numbers stamped on the caps should be on the same side as the numbers on the block.

If there is an arrow on cap, arrow must be on the camshaft side of the block pointing towards the front of the engine. If bearing caps have been rebored, make sure bearing caps have numbers stamped on them. 9. Turn crankshaft by hand. If it does not turn easily, disassemble parts and determine the cause. 10. Install connecting rod bearings and connecting rods caps. See INSTALL PISTONS AND CONNECTING RODS in Group 10. 11. Check crankshaft for 0.038—0.380 mm (0.0015—0.0150 in.) end play. IMPORTANT: Do not use pneumatic wrench to install main bearing cap screws, as damage may occur to threads. 12. Install oil pump and check drive gear-to-crankshaft clearance.

See INSTALL ENGINE OIL PUMP in Group 20. 4. Before tightening cap screws on main bearing caps, align upper and lower thrust flanges on main thrust bearings. Using a soft-face hammer, tap crankshaft to the rear and then to the front to line up thrust bearing flanges. CTM42 (24MAR95) 15-42 6076 Diesel Engines—S.N. (500000— ) RG,CTM42,G15,22-19-03MAY93 160101 PN=171