John Deere 400 6076 — John Deere 400 6076 User Manual

Crankshaft, Main Bearings and Flywheel/Install Main Bearings and Crankshaft INSTALL MAIN BEARINGS AND CRANKSHAFT IMPORTANT: If new main or thrust bearing inserts or thrust washers are installed, they must be installed as a matched set. During assembly, apply a liberal coating of clean engine oil to: RG5892 -UN-13AUG91 R24545 -UN-15DEC88 —All main bearing webs in block —Both sides of main bearing inserts, thrust bearing inserts, and thrust washers —Entire OD of crankshaft main bearing journal No. 5 Main Thrust Bearing Assembly 1. Install six main bearing inserts in block except No. 5 thrust bearing insert. Be sure locating tabs on inserts are properly positioned with slot in block web.

IMPORTANT: Thrust washers (A,C) go on both sides of bearing cap and thrust washer (B) on rear side of block web only with the slots facing the crankshaft. 2. Install No. 5 main thrust bearing insert (D) in block. Install upper thrust washer on bearing insert at rear of block web. Be sure tangs on washer are properly positioned on thrust bearing insert. 15 41 3. Check to make sure that oil holes in main bearing web are properly aligned with oil holes in bearing inserts.

A—Lower Rear Thrust Washer B—Upper Rear Thrust Washer C—Lower Front Thrust Washer D—Main Bearing Block Thrust Bearing E—Main Bearing Cap Thrust Bearing F—Large Tang G—Small Tang RG,CTM42,G15,21-19-14SEP94 CTM42 (24MAR95) 15-41 6076 Diesel Engines—S.N. (500000— ) 160101 PN=170