Crankshaft, Main Bearings and Flywheel/Install Crankshaft Rear Oil Seal Housing IMPORTANT: Installation tools must be clean to assure proper positioning on crankshaft flange and to hold runout within specification so oil seal does not fail prematurely. NOTE: For oil seal housings stamped R78124, use JDG748 Driver*. For oil seal housings stamped R115050, use JDG796 Alignment Tool. 3. Slip the proper tool (A) over crankshaft flange and into seal housing bore to center oil seal housing. The driver is designed to center the oil seal housing in relation to crankshaft flange. However, the use of a magnetic base dial indicator is still recommended to measure the seal housing runout.
Runout should not exceed 0.15 mm (0.006 in.). RG4638 -UN-14DEC88 RG6427 -UN-13OCT92 4. Position bottom of oil seal housing flush (B) with cylinder block-to-oil pan mating surface. Tighten seal housing cap screws to 27 N·m (20 lb-ft), using sequence shown in bottom illustration, beginning with cap screw No. 1. 5. Remove driver from end of crankshaft flange. 15 44 6. Check oil seal housing runout with a magnetic base dial indicator. See CHECK OIL SEAL HOUSING RUNOUT, later in this group. 7. Trim off excess gasket material extending below bottom of oil seal housing. *From JDG476(85) Oil Seal and Wear Sleeve Installer Set. RG,CTM42,G15,25-19-16AUG94 CTM42 (24MAR95) 15-44 6076 Diesel Engines—S.N.
(500000— ) 160101 PN=173