Crankshaft, Main Bearings and Flywheel/Install Front Wear Sleeve INSTALL TIMING GEAR COVER IMPORTANT: Tightening the timing gear cover cap screws in numerical sequence controls the total runout of the front crankshaft oil seal. RG5828 -UN-12AUG91 RG5783 -UN-13OCT92 1. Install a new gasket on the engine block. Lightly grease the gasket to hold it in place. Install timing gear cover (C). Tighten cap screws in sequence one through nine (as shown) to 27 N·m (20 lb-ft). 2. Trim timing gear cover gasket flush with oil pan gasket rail. 3. Lightly grease and install a new injection pump drive gear cover gasket on timing gear cover. Install cover (B). Tighten cap screws to 27 N·m (20 lb-ft). 4.
Using a new O-ring, install magnetic pickup (A, if equipped) in timing gear cover and tighten to 14 N·m (10 lb-ft). 15 48 RG,CTM42,G15,30-19-24MAR95 INSTALL FRONT WEAR SLEEVE NOTE: Front wear sleeve can be installed with timing gear cover removed or installed. 1. Coat I.D. of new wear sleeve (if removed) with LOCTITE 609 Retaining Compound or equivalent. RG5879 -UN-13AUG91 2. Use the JDE3 Driver (B), large washer, and cap screw threaded in nose of crankshaft to press on wear sleeve (A). RG,CTM42,G15,29-19-29OCT92 CTM42 (24MAR95) 15-48 6076 Diesel Engines—S.N. (500000— ) 160101 PN=177