Crankshaft, Main Bearings and Flywheel/Install Crankshaft Rear Oil Seal and Wear Sleeve Assembly INSTALL CRANKSHAFT REAR OIL SEAL AND WEAR SLEEVE ASSEMBLY 1. Apply a light coating of LOCTITE 609 Retaining Compound, or equivalent, completely around the leading edge of crankshaft flange. Wipe away any sealant that may have gotten on seal housing bore. RG4639 -UN-14DEC88 IMPORTANT: DO NOT allow sealant to get on any part of wear sleeve OD or on oil seal. 2. Install JDG477(85) Pilot (A) on end of crankshaft using the Allen head cap screws (B) supplied with tool set. Tighten cap screws securely. IMPORTANT: Handle seal and wear sleeve assembly carefully.
If assembly becomes separated, discard these parts and install a new assembly. 3. Carefully start oil seal/wear sleeve assembly (C) over JDG477(85) Pilot and crankshaft flange with open side of seal toward engine. IMPORTANT: When installing the JDG478 Driver on JDG477(85) Pilot and crankshaft flange to position oil seal/wear sleeve assembly, locate crossbar of installer at right angle (90˚) to Allen head cap screws. This allows the crossbar to bottom on pilot, not head of cap screws, assuring correct installation. 15 47 RG,CTM42,G15,26-19-29OCT92 4. Position JDG478 Driver (A) so that hole in the cross plate goes over threaded stud of pilot. Install washer and nut on stud. 5.
Tighten nut to draw JDG478 Driver in until crossbar bottoms on JDG477(85) Pilot. When the tool bottoms, seal and wear ring assembly (B) will be correctly positioned. RG4640 -UN-14DEC88 6. Remove JDG476(85) Tool Set from engine. CTM42 (24MAR95) 15-47 6076 Diesel Engines—S.N. (500000— ) RG,CTM42,G15,27-19-11JUN93 160101 PN=176