Crankshaft, Main Bearings and Flywheel/Crankshaft Rear Oil Seal And Wear Sleeve Handling Precautions CRANKSHAFT REAR OIL SEAL AND WEAR SLEEVE HANDLING PRECAUTIONS Use the following precautions for handling seal and wear sleeve: —Seal (A) and wear sleeve (B) are assembled. DO NOT SEPARATE. If parts become separated, discard and replace with a new assembly. Attempts to reassemble will cause the wear sleeve to damage the seal allowing engine oil to leak past seal. —Always install seal and wear sleeve assembly immediately after removal from plastic bag to avoid possible dirt contamination. —No lubrication of any kind is to contact seal when installing.
Use of a lubricant may result in premature seal failure. RG5575 -UN-07JUL89 —Install oil seal/wear sleeve assembly with the open side of seal and wear sleeve ID chamfer toward the engine. If seal is reversed, engine oil may be lost because grooves in oil seal lip would be incorrect with respect to direction of crankshaft rotation. —Oil seal/wear sleeve assembly MUST be installed with the JDG476(85) Crankshaft Rear Oil Seal Installation Tool Set. Tool set consists of JDG477(85) Pilot and JDG478 Driver. 15 46 S11,2015,GP -19-08MAR94 CTM42 (24MAR95) 15-46 6076 Diesel Engines—S.N. (500000— ) 160101 PN=175