John Deere 400 6076 — John Deere 400 6076 User Manual

Crankshaft, Main Bearings and Flywheel/Install SAE 3 Flywheel Housing 2. Make sure crankshaft Woodruff key is in place, with tab facing forward. Position damper pulley assembly (B) onto crankshaft. 3. Use hardened washer (part of damper assembly) and insert a cap screw that is 25 mm (1 in.) longer than original cap screw (A). Tighten cap screw until it just bottoms out. 4. Remove cap screw and insert original cap screw with same hardened washer. 5. Tighten cap screw to 230 N·m (170 lb-ft). RG5882 -UN-13AUG91 6. Install water bypass pipe. RG,CTM42,G15,31-19-16AUG94 INSTALL SAE 3 FLYWHEEL HOUSING On SAE 1 and SAE 2 flywheel housings, the flywheel housing is installed AFTER the flywheel.

N CAUTION: Flywheel housing (A) is heavy. Plan a proper lifting procedure to avoid personal injury. 15 50 1. On engines requiring a gasket between block and flywheel housing, inspect cylinder block and flywheel housing gasket surfaces to see that they are clean. Scrape off all old gasket material. Install a new gasket without sealant between block and flywheel housing. RG5005 -UN-14DEC88 2. Install flywheel housing on cylinder block. NOTE: Use new cap screws when installing flywheel housing. 3. Dip threads of cap screw in engine oil before installing. Install and tighten cap screws to 407 N·m (300 lb-ft). S11,2015,GL -19-29OCT92 CTM42 (24MAR95) 15-50 6076 Diesel Engines—S.N.

(500000— ) 160101 PN=179