John Deere 400 6076 — John Deere 400 6076 User Manual

Crankshaft, Main Bearings and Flywheel/Install SAE 1 and SAE 2 Flywheel Housing INSTALL FLYWHEEL Two guide studs may be used to aid in flywheel installation. N CAUTION: Flywheel is heavy. Plan a proper handling procedure to avoid personal injuries. RG4383 -UN-14DEC88 NOTE: ALWAYS use new cap screws when installing flywheel. Flywheel must be clean and free of oil before installing. 1. Coat threads of flywheel attaching cap screws with LOCTITE 242 or its equivalent. 2. Position flywheel over dowel pin (A) and install drive hub (if equipped). Start four cap screws. Remove guide studs and install remaining cap screws. 3. Install remaining flywheel attaching cap screws. 4.

Tighten flywheel attaching cap screws to 115 N·m (85 lb-ft). S11,2020,L -19-29OCT92 15 51 INSTALL SAE 1 AND SAE 2 FLYWHEEL HOUSING On SAE 3 flywheel housings, the housing MUST be installed BEFORE installing flywheel. N CAUTION: Flywheel housing is heavy. Plan a proper lifting procedures to avoid personal injury. 1. Scrape off all old gasket material. Install a new gasket without sealant between block and flywheel housing, if equipped. 2. Install flywheel housing on cylinder block. NOTE: ALWAYS use new cap screws when installing flywheel housing. 3. Dip threads of cap screw in engine oil before installing. Install and tighten cap screws to 407 N·m (300 lb-ft).

CTM42 (24MAR95) 15-51 6076 Diesel Engines—S.N. (500000— ) S11,2015,GT -19-29OCT92 160101 PN=180