Camshaft and Timing Gear Train/Remove Camshaft REMOVE CAMSHAFT NOTE: It is not necessary to remove cylinder head from engine for camshaft removal. If push rods are bent or show excessive scuffing, it may be necessary to remove cylinder head for inspection of block, head, cam lobes and cam followers. RG5764 -UN-06AUG91 1. Drain engine oil and coolant, if not previously done. 2. Disconnect turbocharger oil inlet line at turbocharger or oil conditioning housing. 3. Set engine at No. 1 cylinder’s “TDC-Compression” stroke with JDE81-4 Timing Pin. (See Group 05, Cylinder Head and Valves.) 4. Remove rocker arm cover, rocker arm assembly and push rods. Remove cylinder head, if desired.
(See Group 05, Cylinder Head and Valves.) RG,CTM42,G16,32-19-29OCT92 5. When removing camshaft with engine on rollover stand, roll engine to a vertical position (horizontal shown) and hold cam followers away from camshaft lobes with D15001NU Magnetic Holding Set. 16 9 RG5778 -UN-06AUG91 RG,CTM42,G16,33-19-29OCT92 CTM42 (24MAR95) 16-9 6076 Diesel Engines—S.N. (500000— ) 160101 PN=190