Camshaft and Timing Gear Train/Install Camshaft IMPORTANT: Oil holes in bushings and cylinder block must be aligned after installation. The elongated hole in bushing must be toward top. After installation, use a small mirror with extension to be sure oil holes are properly aligned. 4. Slide a new camshaft bushing (B) onto JDG607 Bushing Driver (A). With JDG608 Bushing Pilot installed in outside cylinder block web (C), assemble D01299AA Slide Hammer (E) and JDG408 Slide Hammer Adapter (D) with bushing driver as shown. RG5333 -UN-06DEC88 5. Be sure bushing is started square in bore and oil holes are aligned with holes in block.
Pull bushing into bore with slide hammer until properly positioned. 6. Check bushing-to-cylinder block alignment using a A—Bushing Driver (JDG607) small mirror with extension. B—Camshaft Bushing C—Cylinder Block Web 7. Apply PERMATEX AVIATION (Form-A-Gasket No. 3) D—Slide Hammer Adapter (JDG408) E—Slide Hammer (D01299AA) to new camshaft bore steel cap plug and install plug in bore. Plug edge must be seated below edge of bore. S55,2016,P -19-29OCT92 INSTALL CAMSHAFT 16 18 IMPORTANT: Set engine at TDC of No. 1 piston’s compression stroke before installing camshaft so timing marks on camshaft and crankshaft gears will be aligned. 1.
If camshaft followers were removed with engine on a rollover stand, reinstall followers but do not obstruct camshaft bore. Roll engine to an angle where followers fall away from camshaft bores. RG5780 -UN-06AUG91 NOTE: If D15001NU Magnetic Holding Tool Set is used, hold camshaft followers away from camshaft bore until camshaft is installed. 2. Lubricate thrust washer (A) with TY6333 or TY6347 High Temperature Grease and install on camshaft behind inner gear. 3. Lubricate camshaft lobes with TY6333 or TY6347 High Temperature Grease and bearing journals with clean engine oil. CTM42 (24MAR95) 16-18 6076 Diesel Engines—S.N. (500000— ) RG,CTM42,G16,25-19-29OCT92 160101 PN=199