John Deere 400 6076 — John Deere 400 6076 User Manual

Camshaft and Timing Gear Train/Service Camshaft Bushings using JDG606 Adapter Set SERVICE CAMSHAFT BUSHINGS USING JDG606 ADAPTER SET 1. Inspect camshaft journals and bushings for wear or damage. Measure cam journals and bushings to determine if proper oil clearance exists. Replace camshaft and/or bushings as necessary. CAMSHAFT JOURNAL AND BUSHING NEW PART SPECIFICATIONS Camshaft Bushing Bore in Block . . . . . . . . . . . . 69.987—70.013 mm (2.7554—2.7564 in.) RG5332 -UN-06DEC88 RG5949 -UN-30AUG91 Journal OD . . . . . . . . . . . . . . . . . . . . . . . . . . 66.987—67.013 mm (2.6373—2.6383 in.) Bushing ID . . . . . . . . . . . . . . . . . . . . . . . . . . .

67.076—67.102 mm (2.6408—2.6418 in.) Oil Clearance . . . . . . . . . . . . . . . . . . . . . . . . . . 0.063—0.115 mm (0.0025—0.0045 in.) NOTE: The front two bushings can be reached from the front of the engine. The flywheel and rear camshaft bore plug (G) must be removed to reach the other two bushings. Lubricate O-ring on JDG608 Bushing Pilot with clean engine oil before installing in cylinder block web (C). 2. Remove camshaft bushing (B) using JDG607 Bushing Driver (A), JDG408 Slide Hammer Adapter (D) (from JDG405 Camshaft Bushing Service Set), JDG608 A—Bushing Driver (JDG607) Bushing Pilot (E), and D01299AA Slide Hammer (F). B—Camshaft Bushing C—Cylinder Block Web NOTE:

End bushing at front and rear of cylinder block D—Slide Hammer Adapter (JDG408) may be removed with just JDG607 Bushing E—Bushing Pilot (JDG608) Driver and D01299AA Slide Hammer. F—Slide Hammer (D01299AA) G—Camshaft Bore Plug 3. Inspect and measure each camshaft bushing bore in block as bushings are removed. 16 17 RG,CTM42,G16,31-19-15SEP94 CTM42 (24MAR95) 16-17 6076 Diesel Engines—S.N. (500000— ) 160101 PN=198