Camshaft and Timing Gear Train/Service Camshaft Bushings using JDG602 Adapter Set IMPORTANT: Oil holes in bushings and cylinder block must be aligned after installation or oil starvation will occur. The elongated hole in bushing must be toward the top. After installation, use a small mirror with extension to be sure oil holes are properly aligned. 4. Slide a new camshaft bushing (F) onto JDG603 Bushing Driver (E). Assemble driver and JDG604 Receiver Cup (D) along with components shown from JDE6 Camshaft Bushing Replacement Set (A and C). RG5273 -UN-06DEC88 5. Be sure bushing is started square in bore and oil holes are aligned with holes in block.
Tighten nut to pull bushing in until it is properly positioned in bore. 6. Check bushing-to-cylinder block oil hole alignment A—Bushing Screw (JDE6-1) using a small mirror with extension. B—Cylinder Block Web C—Lock Bushing (No. 25916) D—Receiver Cup (JDG604) E—Bushing Driver (JDG603) F—Camshaft Bushing S55,2016,N -19-23SEP91 16 16 CTM42 (24MAR95) 16-16 6076 Diesel Engines—S.N. (500000— ) 160101 PN=197