Camshaft and Timing Gear Train/Service Camshaft Bushings using JDG602 Adapter Set SERVICE CAMSHAFT BUSHINGS USING JDG602 ADAPTER SET 1. Inspect camshaft journals and bushings for wear or damage. Measure cam journals and bushings to determine if proper oil clearance exists. Replace camshaft and/or bushings as necessary. CAMSHAFT JOURNAL AND BUSHING NEW PART SPECIFICATION Camshaft Bushing Bore in Block . . . . . . . . . . . . 69.987—70.013 mm (2.7554—2.7564 in.) RG5272 -UN-06DEC88 RG5949 -UN-30AUG91 Journal OD . . . . . . . . . . . . . . . . . . . . . . . . . . 66.987—67.013 mm (2.6373—2.6383 in.) Bushing ID . . . . . . . . . . . . . . . . . . . . . . . . . . .
67.076—67.102 mm (2.6408—2.6418 in.) Oil Clearance . . . . . . . . . . . . . . . . . . . . . . . . . . 0.063—0.115 mm (0.0025—0.0045 in.) NOTE: The front two bushings can be reached from the front of the engine. The flywheel and rear camshaft bore plug (G) must be removed to reach the other two bushings. 2. Remove camshaft bushings (F) using JDG603 Bushing Driver (E) and JDG604 Receiver Cup (D) along with the components shown from JDE6 Camshaft Bushing Replacement Set (A and C). 3. Tighten nut on end of bushing screw until bushing is pulled out of camshaft bushing bore. Inspect and measure camshaft bushing bore in block (B).
Follow A—Bushing Screw (JDE6-1) B—Cylinder Block Web same procedure for remaining bushings to be replaced. C—Lock Bushing (No. 25916) D—Receiver Cup (JDG604) E—Bushing Driver (JDG603) F—Camshaft Bushing G—Camshaft Bore Plug 16 15 RG,CTM42,G16,30-19-15SEP94 CTM42 (24MAR95) 16-15 6076 Diesel Engines—S.N. (500000— ) 160101 PN=196