John Deere 400 6076 — John Deere 400 6076 User Manual

Lubrication System/Tighten cap screws on front frame/oil sump TIGHTEN CAP SCREWS ON FRONT FRAME/OIL SUMP RG7223 -UN-21JUN94 A—0.375 x 7.625 in. (2 used) C—0.500 x 6.000 in. (8 used) E—0.500 x 2.500 in. (6 used) F—0.375 x 1.875 in. (2 used) B—0.500 x 4.000 in. (4 used) D—0.375 x 2.500 in. (2 used) 20 15 1. Be sure dowel pins are in place. 4. Install all 3/8 in. and 1/2 in. cap screws in their appropriate locations. IMPORTANT: DO NOT apply gasket sealant to gasket, front frame/oil sump, trimmed edges of timing gear cover gasket, oil seal housing gasket, or cylinder block mating surfaces. Before installing engine, be sure mating surfaces of engine and front frame/oil sump are clean. 5.

Tighten all 1/2 in. cap screws to 133 N·m (98 lb-ft). Tighten all 3/8 in. cap screws to 58 N·m (43 lb-ft). 6. Re-tighten all 3/8 in. cap screws to 58 N·m (43 lb-ft). Re-tighten all 1/2 in. cap screws to 133 N·m (98 lb-ft). 2. Install front frame/oil sump-to-cylinder block gasket. 7. Apply clean engine oil to new O-ring for bottom drain plug and install drain plug. 3. Carefully lower engine onto front frame/oil sump. CTM42 (24MAR95) 20-15 6076 Diesel Engines—S.N. (500000— ) RG,CTM42,G20,33-19-17MAR95 160101 PN=218