Lubrication System/Install Oil Pan INSTALL OIL PAN Before installing oil pan, remove old gasket and sealant material from pan and cylinder block mating surfaces. Guide studs may be used if desired. RG5010 -UN-29NOV88 1. Apply a thin layer of PERMATEX AVIATION (Form-A-Gasket No. 3) across entire front and rear gasket rail of block. Install gasket (A) onto cylinder block and apply a layer of sealant to gasket across front and rear gasket face. On engines equipped with multi-piece gaskets, also apply sealant to mating joints. Install oil pan. 2. Insert all 3/8 in. and 1/2 in. cap screws in their appropriate locations. 3.
Use a straightedge against oil pan and cylinder block (flywheel end) to be sure oil pan is flush with block flange. 4. Proceeding counterclockwise (bold arrows) from flywheel end (B), tighten all cap screws to 47 N·m (35 lb-ft). 5. Repeat sequence by tightening all 3/8 in. cap screws to 68 N·m (50 lb-ft). 6. Complete sequence by tightening counterclockwise all 1/2 in. cap screws to 156 N·m (115 lb-ft). Check torque on all 3/8 in. cap screws after final torque of 1/2 in. cap screws. Trim gasket flush with rear of pan flange. 7. Bottom oil pan drain plug (D) uses either an aluminum washer or rubber O-ring (C) for sealing.
Apply a light coat of engine oil to new rubber O-rings for bottom drain plug. Install aluminum washer on drain plug so raised center contacts head of plug. 20 14 RG5267 -UN-29NOV88 Some engine oil pans may be equipped with an elbow fitting (E) and drain hose (F). 8. Install drain plug and tighten to specifications listed below. Fill engine crankcase with correct engine oil. A—Oil Pan Gasket OIL PAN DRAIN PLUG TORQUE SPECIFICATIONS B—Location For First Cap Screw Aluminum Oil Pans . . . . . . . . . . . . . . . . . . . . . . 102 N·m (75 lb-ft) C—O-Ring or Aluminum Washer Cast Iron Oil Pans . . . . . . . . . . . . . . . . . . . . . . . 47 N·m (35 lb-ft) D—Drain Plug E—Elbow Fitting NOTE:
On engine equipped with elbow fittings and drain F—Drain Hose hose, the threads and sealing surfaces must be free of any oil film to insure an effective seal. Apply a light coat of LOCTITE 592 to fittings except for the leading one to three threads. Tighten fittings securely. CTM42 (24MAR95) 20-14 6076 Diesel Engines—S.N. (500000— ) S55,2020,O -19-16AUG94 160101 PN=217