John Deere 400 6076 — John Deere 400 6076 User Manual

Lubrication System/Install Engine Oil Pump INSTALL ENGINE OIL PUMP 1. Lubricate bottom surface of oil pump housing gear pocket bores, idler shaft, gear teeth on drive shaft, and oil pump cover ends of both gears with TY6333 or TY6347 High Temperature Grease. 2. Tighten oil pump drive gear-to-drive shaft nut (A) to 54 N·m (40 lb-ft). Install oil pump cover (B)-to-oil pump housing (C). 3. Using a new gasket, install oil pump intake (F)-to-oil pump cover and tighten cap screws to 41 N·m (30 lb-ft). RG5922 -UN-16AUG91 NOTE: Oil pump gears must turn freely after installation of oil pump cover and intake. 4. Install oil pump assembly over hollow dowel pin in cylinder block.

Tighten oil pump housing-to-cylinder block cap screws to 47 N·m (35 lb-ft). A—Shaft Nut NOTE: Make sure oil pump drive gear (D) meshes B—Oil Pump Cover properly with crankshaft gear (E). C—Oil Pump Housing D—Oil Pump Drive Gear E—Crankshaft Gear F—Oil Pump Intake RG,CTM42,G20,23-19-16AUG94 IMPORTANT: Push crankshaft rearward (toward flywheel end). Check clearance between oil pump drive gear face and throw of crankshaft. There should be a clearance of at least 0.38 mm (0.0015 in.). If clearance is below specification, check thrust bearings for proper placement.

Gently pry crankshaft forward and check (after oil pump is installed) the oil pump drive gear (A), and crankshaft gear (B) to see that they are properly meshed. 20 13 RG5923 -UN-20AUG91 RG,CTM42,G20,24-19-22AUG91 CTM42 (24MAR95) 20-13 6076 Diesel Engines—S.N. (500000— ) 160101 PN=216