Cooling System/Replace Bearings in Standard Duty, Adjustable Fan Drive Assembly REPLACE BEARINGS IN STANDARD DUTY, ADJUSTABLE FAN DRIVE ASSEMBLY RG7305 -UN-13MAR95 A—Fan Hub/Pulley B—Bearing Housing C—Bearing/Shaft D—Support Plate • To Disassemble Fan Drive: STANDARD DUTY, ADJUSTABLE FAN DRIVE SPECIFICATIONS 1. Remove V-belt and remove support plate (D) with fan drive assembly. Housing ID . . . . . . . . . 47.576—47.612 mm (1.8731—1.8745 in.) Bearing OD . . . . . . . . 47.612—47.625 mm (1.8745—1.8750 in.) 2. Remove fan drive assembly from support plate. Shaft OD . . . . . . . . . . 25.387—25.400 mm (0.9954—1.0000 in.) 3.
Support back side of fan hub/pulley (A), and press bearing/shaft (C) out of hub bore. Pulley ID . . . . . . . . . . 25.336—25.362 mm (0.9975—0.9985 in.) Shaft Installed Dimension From Pulley Front Face . . . . . . . . . . . . Flush to 1.30 mm (0.05 in.) Below 25 6 4. Support back side of bearing housing (B) and press bearing/shaft out of housing. Discard bearing. Replace parts that are cracked or not within specification. 5. Thoroughly clean and inspect fan hub/pulley and bearing housing for cracks or any other damage. Measure parts and compare with specifications given later. CTM42 (24MAR95) 25-6 6076 Diesel Engines—S.N. (500000— ) RG,CTM42,G25,44-19-21MAR95 160101 PN=225