John Deere 400 6076 — John Deere 400 6076 User Manual

Cooling System/Replace Bearings in Standard Duty, Adjustable Fan Drive Assembly RG7305 -UN-13MAR95 A—Fan Hub/Pulley B—Bearing Housing C—Bearing/Shaft D—Support Plate To Assemble Fan Drive: 5. Install fan drive housing assembly onto support plate (D). Tighten four cap screws with washers to 80 N·m (60 lb-ft). 1. Support front nose of bearing housing (B) with ID open so bearing/shaft (B) can pass through opening when installed. 6. Install support plate onto engine. Tighten 5/16-in. cap screws to 27 N·m (20 lb-ft) and 3/8-in. cap screws to 47 N·m (35 lb-ft). 2. Press on outer shell of bearing and install bearing into housing until bearing bottoms.

Shaft end of bearing will protrude from hoousing. 7. Install V-belts and position onto belt tensioner. 3. Support inner portion of bearing and press fan hub/pulley (A) omto shaft until shaft is flush to 1.30 mm (0.05 in.) below front face of pulley. 25 7 4. Spin pulley by hand to assure assembly turns freely and bearing was not damaged during assembly. RG,CTM42,G25,45-19-21MAR95 CTM42 (24MAR95) 25-7 6076 Diesel Engines—S.N. (500000— ) 160101 PN=226