John Deere 400 6076 — John Deere 400 6076 User Manual

Cooling System/Replace Bearings in Heavy Duty, Adjustable Fan Drive Assembly RG5760 -UN-06AUG91 A—Fan Hub/Pulley D—Ball Bearing (2 used) F—Bearing Housing H—Support Spacer B—Grease Seal E—Shaft G—Pipe Plug J—Support Plate C—Snap Ring • To Assemble Fan Drive: 7. Apply a thin coat of clean engine oil to OD of seal casing (B) and to seal lips. Install seal in housing bore until metal casing is flush-to-0.50 mm (0.020 in.) below housing face. 1. Pack inner and outer bearings (D) with TY6333 or TY6347 High Temperature Grease. Apply clean engine oil to bearing ID and shaft OD. 8. Apply clean engine oil to ID of fan hub/pulley (A).

Support end of shaft through pipe plug hole in bearing housing and push hub onto other end of shaft until it bottoms against shoulder. 2. Support end of shaft (E) and install bearings against shoulder. Apply force to bearing inner race only. 3. Support bearing housing (F) on a firm flat surface with bearing bore in the upward position. 9. Install washer and cap screw. Tighten cap screw to 80 N·m (60 lb-ft). 25 9 4. Install bearing and shaft assembly into housing. Small end of shaft should extend through housing. 10. Apply LOCTITE 592 Pipe Sealant to threads of pipe plug (G). Install and tighten plug in bearing housing. 5.

Determine proper snap ring (C) thickness needed to obtain 0.10 mm (0.004 in.) end play. 11. Install fan drive assembly onto support plate (J). 6. Install snap ring in housing groove. Visually inspect snap ring installation for proper seating in housing groove. 12. Install support plate assembly onto engine and tighten 5/16-in mounting cap screws to 27 N·m (20 lb-ft) and all 3/8-in. cap screws to 47 N·m (35 lb-ft). CTM42 (24MAR95) 25-9 6076 Diesel Engines—S.N. (500000— ) RG,CTM42,G25,3 -19-17MAR95 160101 PN=228