John Deere 400 6076 — John Deere 400 6076 User Manual

Cooling System/Water Manifold Mounted Fixed Fan Drive Assembly REPLACE BEARINGS IN WATER MANIFOLD MOUNTED, FIXED FAN DRIVE ASSEMBLY RG6437 -UN-13OCT92 A—Water Manifold C—Bearing E—Hub* B—Fan Pulley D—Bearing Shaft Installed Dimension • To Disassemble Fan Drive: WATER MANIFOLD MOUNTED, FIXED FAN DRIVE SPECIFICATIONS 1. Remove three water manifold-to-cylinder head cap screws. Remove water manifold (A) and fan pulley (B) assembly from cylinder head and lift to dislodge water bypass pipe from manifold. Shaft OD . . . . . . . . . . . . . . . . . . . . . . . . . 25.387—25.400 mm (0.9995—1.0000 in.) Bearing OD . . . . . . . . . . . . . . . . . . . . . . . 47.612—47.625 mm (1.8745—1.8750 in.) 2.

Support front face of water manifold and use a press to push bearing (C) and pulley out of manifold. Pulley ID, Bearing End . . . . . . . . . . . . . . . . 47.576—47.612 mm (1.8731—1.8745 in.) 3. Support front face of fan pulley and push bearing out of pulley, and fan spacer (if equipped). Discard bearing. Pulley ID, Fan Spacer End** . . . . . . . . . . . . 49.485—49.518 mm (1.9482—1.9495 in.) Fan Spacer OD** . . . . . . . . . . . . . . . . . . . 49.457—49.483 mm (1.9471—1.9481 in.) 25 10 4. Thoroughly inspect water manifold and pulley for cracks or damage. Measure parts and compare readings with specifications given below. Replace parts as necessary. Manifold ID . . . . . . . . . . . . . .

. . . . . . . . . . 25.336—25.362 mm (0.9975—0.9985 in.) IMPORTANT: Support fan pulley on a flat, firm surface and press on bearing outer race to prevent damage to the bearing. Shaft Installed Dimension from Manifold Mounting Face-to-End of Shaft . . . . . . . . . . 33.31—33.47 mm (1.311—1.318 in.) 5. Install new bearing into pulley until outer race bottoms in bore of pulley. End of shaft will extend through bearing stop. *In some applications, bearing is pressed into hub (E). The fan spacer and pulley are then bolted to hub. In some applications, the fan spacer is press-fit into the pulley. Dimension (D) is the same for all applications. **Units with press-fit fan spacer only.

CTM42 (24MAR95) 25-10 6076 Diesel Engines—S.N. (500000— ) RG,CTM42,G25,10-19-14FEB95 160101 PN=229