Cooling System/Disassemble Water Pump 1. Remove four cap screws and remove cover (A) from housing (B). 2. Remove and discard gasket. Scrape all gasket material from cover and housing face. RG5851 -UN-13AUG91 RG,CTM42,G25,14-19-12SEP91 3. Remove the water pump gear (I) by supporting the back side of the gear with D01217AA Bearing Puller and using D01206AA Puller to pull the gear off of the bearing shaft. RG5840 -UN-13AUG91 RG,CTM42,G25,16-19-12SEP91 4. Roll oil seal lip (H) using a punch and hammer. Using needle nose pliers, remove and discard oil seal. 5. Using a press, remove bearing (G), water pump seal (F), and impeller (not shown).
Support pump housing (B) on gasket surface so that impeller will clear the supports and press on the outer race of the bearing from the gear end with JDG727 Bearing Driver. Discard bearing, seal, and impeller. RG5841 -UN-13AUG91 25 16 NOTE: It is not recommended that bearing and impeller be reused once they have been removed from the water pump. A new bearing, water pump seal, and impeller are provided in water pump overhaul kit. RG,CTM42,G25,17-19-29OCT92 CTM42 (24MAR95) 25-16 6076 Diesel Engines—S.N. (500000— ) 160101 PN=235