Cooling System/Inspect Water Pump Parts INSPECT WATER PUMP PARTS 1. Measure water pump housing bore ID (A) and drive gear ID (B). Replace parts if worn, damaged, cracked, or not within specifications. WATER PUMP SPECIFICATIONS Impeller Bore ID . . . . . . . . . . . . . . . . . . . . . . . 15.849—15.875 mm (0.624—0.625 in.) Shaft OD Impeller End . . . . . . . . . . . . . . . . . . . 15.905—15.917 mm (0.626—0.627 in.) Bearing Bore in Water Pump Housing (NEW) . . . . . . . . . . . . . . . . . . . . . . . 38.041—38.067 mm (1.498—1.499 in.) Maximum Allowable Pump Bearing Bore . . . . . . . . . . . . . . . . . . . . . . 38.067 mm (1.499 in.) RG5843 -UN-13AUG91 Bearing OD . . . . . . . . . . . . .
. . . . . . . . . . . . . 38.087—38.100 mm (1.499—1.500 in.) Drive Gear Bore ID . . . . . . . . . . . . . . . . . . . . . . 18.90—18.92 mm (0.744—0.745 in.) Shaft OD Drive Gear End . . . . . . . . . . . . . . . . . 18.948—18.960 mm (0.746—0.747 in.) Water Pump Seal Installed Height . . . . . . . . . . . . 10.16—10.42 mm (0.400—0.410 in.) Impeller Installed Depth Below Gasket Surface . . . . . . . . . . . . . . . . . . . . . 2.75—3.50 mm (0.108—0.138 in.) Bearing Installed Depth Below Pump Housing Nose . . . . . . . . . . . . . . . . . . 6.75—7.00 mm (0.266—0.276 in.) 2. Clean gear and housing with clean solvent and dry with compressed air. 3.
Inspect water pump housing for debris, cracks, or damage. Be sure the “weep holes” in the housing are cleaned and foam filters (C) are removed from weep holes while pump is disassembled. 25 18 NOTE: Make sure all gasket material is removed from pump. RG,CTM42,G25,18-19-29OCT92 CTM42 (24MAR95) 25-18 6076 Diesel Engines—S.N. (500000— ) 160101 PN=237