John Deere 400 6076 — John Deere 400 6076 User Manual

Cooling System/Assemble Water Pump ASSEMBLE ENGINE WATER PUMP IMPORTANT: When installing water pump bearing into housing, press only on outer bearing race. Do NOT press on bearing shaft as this will damage the bearing. 1. Support pump housing on gasket surface. Using JDG727 Bearing Driver, press a new bearing into drive gear end of pump housing until outer race is 6.75—7.00 mm (0.266—0.276 in.) below nose of housing. Press only on outer race. Bearing driver will bottom against nose of housing, leaving bearing at correct depth. RG5844 -UN-13AUG91 RG5845 -UN-13AUG91 2. Apply a light film of clean engine oil to the drive gear end of shaft and to the oil seal lip.

Install the new oil seal with spring loaded lip facing outward toward gear end of bearing shaft. Seal should be installed flush with housing nose. RG,CTM42,G25,19-19-23FEB93 25 19 CTM42 (24MAR95) 25-19 6076 Diesel Engines—S.N. (500000— ) 160101 PN=238