Cooling System/Assemble Water Pump IMPORTANT: When installing drive gear, support impeller end of shaft so pressing load is transmitted through the shaft. Bearing damage will result if load is transmitted through the outer bearing race. RG5846 -UN-13AUG91 RG5848 -UN-13AUG91 3. Support water pump on impeller end of bearing shaft. Press drive gear onto shaft until gear is flush with end of shaft. IMPORTANT: When installing water pump seal, support drive gear end of shaft so pressing load is transmitted through the shaft. 4.
Support water pump on gear end of bearing shaft and use R113749 Seal Driver (A) (supplied with water pump overhaul kit) and JDG727 Water Pump Bearing Driver to install a new water pump seal. Seal height (B) should be 10.16—10.42 mm (0.400—0.410 in.) when properly installed. R113749 Seal Driver will install seal to proper height. RG,CTM42,G25,37-19-04FEB93 IMPORTANT: When installing impeller, support drive gear end of shaft so pressing load is transmitted through the shaft. Bearing damage will result if load is transmitted through the outer bearing race. 25 20 5.
Support water pump on gear end of bearing shaft and press new impeller (A) onto shaft until impeller face is 2.97—3.23 mm (0.117—0.127 in.) below gasket surface (B). Use straightedge and dial caliper from bottom of straightedge to impeller to measure depth specification. Pump impeller must rotate freely. Disassemble and correct problem if interference is felt. RG5849 -UN-15OCT92 CTM42 (24MAR95) 25-20 6076 Diesel Engines—S.N. (500000— ) RG,CTM42,G25,20-19-29OCT92 160101 PN=239